Generic picture that may not coincide with the real product.
PISTON + TOP END GASKET
Buying 1 piston and 1 top end gasket, you'll receive a 10% discount on both parts.
Not combinable with other offers, outlet or promo codes. Motorcycle, Bikes and OEM parts are excluded from the offer.
No codes, discount applied directly when you add the products to your cart.
10% discount on purchases over $100. Not combinable with other offers, outlet or promo codes. Motorcycle, Bikes and OEM parts are excluded from the offer. Some brands may be excluded from the offer. The discount will be applied once the promo code is entered in the cart.
Discount valid until 07/10/2023 at 23h59 CEST..
- Italian made, pistons for high-performance motorcycle racing applications.
- Vertex are the unique piston profiles and compression ratios that are offered in a, b, c and d sizes.
- This variation in sizing, a mere 0.
- Allows the piston to be perfectly sized to the cylinder for maximizing power and performance while reducing blow-by and oil consumption.
- You can specify in remarks, piston details.
|Season||EVO Plus (97-02)|
HOW TO MEASSURE ANY DIRT BIKE´S PISTONS
The pistons of any internal combustion engine, two or four-stroke, are conical and oval, to control its expansion in its operation. To get to know your maximum measurement you have to measure at 10-12 mm. of the skirt, in the opposite part to the bolt.
When we see a mark on the head of the piston, for example, 80 mm. or we have a cylinder of 80 mm. this measure is corresponds to the cylinder, when meassuing the piston we will see that actually measurement is 79.95 mm., the tolerance between piston and cylinder would be 5 cents (0.05 mm.).
In the aluminum cylinders with hard chrome interior treatment, already in disuse, or NIKASIL the measure of 80 mm. It is usually fixed to 80 mm.
The pistons work with tolerances between 4 to 6 hundredths (0.04-0.06) for two-stroke engines and 3 to 4 hundredths for four-stroke engines (0.03-0.04). To fix a deformed cylinder, the interior of the cylinder shall be polished first and the measurement is adjusted with pistons that are over-measured for this purpose, marked with letters A-B-C-D (selection); the lowest measure being A, increasing 1 hundredth per letter; that is, selection B 0.01 mm. greater than A, C 0.02 mm. greater than A, etc.
New Cylinder Ø 80.00 mm. mounts a piston of Ø 79,97 A Factory Tolerance 0.03 mm.
Polished Cylinder Ø 80,01 mm. mounts a piston Ø 79,98 B Factory Tolerance 0,03 mm.
Polished Cylinder Ø 80,02 mm. mounts a piston Ø 79,99 C Factory Tolerance 0,03 mm.
Polished Cylinder Ø 80,03 mm. mounts a piston Ø 80,00 D Factory Tolerance 0,03 mm.
The important thing is to maintain the tolerance, which the manufacturer recommends, between cylinder and piston.