Your browser s Javascript functionality is turned off. Please turn it on so that you can experience the full capabilities of this site.

RENTHAL | Ref: 216U-520-00GPSI

Renthal Ultralight Rear Sprocket Beta/Gas Gas/Husqvarna/Sherco Silver

Generic picture that may not coincide with the real product.

RENTHAL | Ref: 216U-520-00GPSI

Renthal Ultralight Rear Sprocket Beta/Gas Gas/Husqvarna/Sherco Silver

Personalized

Customer Service

Pay less

Get more

Club GMX

Exclusive Discounts

MSRP 66.83€ | You save 17.33€

GMX Price -26%

49 . 50 €

Did you find it cheaper?

Description

Technical details

Ratings

Size guide

Renthal Ultralight Rear Sprocket

Renthal Ultralight rear chainwheels are manufactured to exteremly tight tolerences from a special material developed to withstand the rigours of Supercross, Motocross and Enduro.
The 7075 T6 aluminium alloy rear chainwheels are 66% lighter than steel, yet incredibly durable.
Their advanced tooth profile, concentricity and accuracy of fit provide maximum power transfer and long-life.
Renthal combination of a very high strength base material and an exceptionally hardwearing surface result in significantly increased chainwheel life.
Self cleaning mud groves help prevent dirt build-up.

Brand	Renthal
Modality	Cross/Enduro

Before taking a final decision while selecting a certain front or rear sprocket, we have to bear the following premises in mind:

The higher the number of teeth on your rear sprocket, the shorter the development. Therefore, our dirt bike will improve the delivery of power to low regime, but it will lose top speed.

The higher the number of teeth in our front sprocket, the longer the development. Our dirt bike will lose delivery power at low speed, while gaining top speed.

The lower the number of teeth in our rear sprocket, the longer the development. Therefore, our bike will lose delivery power at low speed, while gaining top speed.

The lower the number of teeth in our front sprocket, the shorter the development. Our bike will gain delivery power at low speed, while losing top speed.

ATENTION: If we decide to vary the number of teeth in our front sprocket, the change will be more noticeable than if we were to do so for our rear sprocket. One tooth difference in our front sprocket, equals the change of three teeth in our rear sprocket.

Therefore, if we want to slightly modify our dirt bike performance, the ideal way to do so would be to increase or decrease one or two teeth in our rear sprocket. Contrariwise, if we want a more noticeable change in the performance, we can choose to increase or decrease the number of teeth on our front sprocket one by one or do the same for the rear sprocket but always changing the teeth on a 3 by 3 basis.

IMPORTANT: every time we decide to modify our dirt bike´s development, we must be extremely cautious not to set an excessively small or large rear or front sprocket up. Such detail could cause the chain to apply excessive forcé onto the chain slider or the chain guide, potentially causing a premature attrition of the latter.

Please, bear in mind that every element of transmission must have a simultaneous wear. It is not advisable to install new crowns and sprockets with worn chains, or new chains with worn crowns and sprockets. The duration and resistance of such components will be severely reduced.

Last but not least: If you were to change your rear sprocket, do not forget to use a screw fixer and give the nuts the proper tightening torque, always in cross fashion.