MOTION PRO
MOTION PRO | Ref: 08-0213

Motion Pro Swing Arm Linkage Bearing Install Tool


  • _Motion Pro Swing Arm Linkage Bearing Install Tool | 08-0213 | Greenland MX_
  • _Motion Pro Swing Arm Linkage Bearing Install Tool | 08-0213 | Greenland MX_

Details

https://www.greenlandmx.com/int/en/motion_pro_swing_arm_linkage_bearing_install_tool/08-0213.html
MOTION PRO
MOTION PRO | Ref: 08-0213

Motion Pro Swing Arm Linkage Bearing Install Tool


Personalized
Customer Service
Pay less
Get more
Club GMX
Exclusive Discounts
🟢GREENWEEK
(*) Discount valid until 23/03/2024 at 23h59 CEST. 10% discount on purchases over £100. Not combinable with other offers, outlet or promo codes. Motorcycle, Bikes and OEM parts are excluded from the offer. Some brands may be excluded from the offer. The discount will be applied once the promo code is entered in the cart.
MSRP 43.46€ | You save 14.54€
GMX Price -33%
28 . 92
Did you find it cheaper?
- +
Temporarily out of stock

COD: GREENWEEK10
-10% EXTRA on +£100

Greenweek

Description
Technical details
Ratings

Motion Pro Swing Arm/Rising Rate Linkage Bearing Install Tool

Designed for use on late model off-road motorcycles from 1990 to present.

This tool has the necessary drivers to fi t the main swing arm needle bearings.

Important maintenance note: Clean and Lubricate the threaded rod before every use.

  • Begin by selecting the correct size driver (see chart) and inserting it into the swingarm bearing. Note: The driver OD must be slightly smaller than the ID of the swing arm.
  • Install the threaded rod through the driver and swing-arm bearing and slide the unit, (bearing rst) into the swing arm until there is an equal amount of thread on each side.
  • Slide the thrust bearing onto the threaded rod next to the driver (with the rounded shoulder side facing the driver) and then slide one of the two solid washers (largest that will t) onto the threaded rod on the opposite side of the swing-arm.
  • Complete the tool assembly by threading a nut onto each side of the threaded rod.
  • Check the tool to insure that it is aligned squarely to the swing-arm bearing and begin tightening the nut outside the thrust bearing.
  • Continue to monitor the bearing alignment until the bearing is seated in the exact location required by the manufacturer’s speci cation.
  • The kit includes 3 sizes of conductors: I.D. 20mm / O.D. 26mm, I.D. 21mm / O.D. 26mm & I.D. 22mm / O.D. 27mm.
  • IMPORTANT: Be sure to drive the bearing to the exact location required by the manufacturer’s speci cation. If in doubt, measure the location of original bearings before their removal.
  • CONTENT LIST: Threaded Rod, Thrust Bearing, D, E and F Drives, Large Washer, Small Washer, Two Nuts.
Brand Motion Pro
Modality All
Compatibility Universal
-

You may also like…

About the brand

Last visited products

  • €43.46 €28.92
    🟢GREENWEEK

    COD: GREENWEEK10
    -10% EXTRA on +£100